A possible problem is that the back side support posts supplied with both goals may appear not to fit the item being too long.
Please note that Part D is 77cm and Part E is 75cm and they are bent in a different angle.
Please construct the goal as follows:
The correct way to assembly the back-support parts is to put part D and E on the frame separately first.
Then connect part D and E with straight-connector then (as below sequence).
If you connect D & E together first, you can see the back support tube is higher than the front frame.
After assembly, the goal should leans forward slightly.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article